Money Tree

Bright, indirect light to filtered sun.

Allow the soil to dry out completely between waterings.

Enjoys moderate to high levels of humidity. Spritz occasionally.

Ideally, the Money Tree likes the room temperature at 72°F. It handles warmth rather than cold so keep it away from cold drafts.

Outside: Grow in morning light, partial shade (4-6 hours) where nights are above 45°F.

Indoors: The Money Tree prefers bright, indirect light for at least six hours in a southern, eastern and western windows.

Fertilize bimonthly during its growing period. Use a balanced liquid fertilizer at 1/2 strength. Reduce during the fall and winter months while the plant is in its dormant phase and refrain from watering as much so it can rest.

When receiving the plant, do not repot immediately but wait at least 6-12 months or if the roots are beginning to get crowded and growing through the drainage holes.

Repot in the spring, using a 2" bigger pot to keep the roots drier. (Too big of a pot could cause the soil to dry slower, which is not helpful.) Use a well-draining indoor potting mix with perlite to help with drainage. Water your plant in the old pot before transferring over and let it sit an hour. Place a piece of screening at the bottom of the container over the drainage hole to secure the soil and allow it to drain.

Add soil to the bottom to elevate the root ball. Lift the plant and release the roots against the existing planter. Use a clean knife or garden trowel to wedge between the pot and the soil to loosen. Inspect the root ball. Notice if there are any dead or rotting roots and trim off with sterile pruners. If the plant is rootbound, cut through the roots to alleviate continued encircling. Ensure the plant is sitting about 1" below the edge of the pot to avoid water spillage. Add more soil and backfill around the sides by tamping down. Fill up to the soil line but not over. Water thoroughly, leaving the soil damp but not soggy. If settling occurs, add more soil.

Prune the leaves to stimulate new growth by cutting in front of a leaf node. Trim off any dead or damaged stems to keep it healthy.

Stem Cutting: In early summer, take a stem cutting, use sharp pruners to remove a cutting from a tip off the vine. Cut at least 4-6 inches of stem to propagate. Place in a vase with water to root. Change the water each week with filtered, bottled, or tap water sitting at least 24 hours. After 3-4 weeks, check to make sure the stem has 1-2 inch, well-formed roots. If so, it's time to plant. *Fill a small container with drainage holes (too large of a container for the cutting will make it challenging to regulate watering needs) using an indoor well-draining potting mix. Mix a little rooting hormone into the soil. Poke a hole in the soil with a pencil. Then, place the cutting in the hole and tamp the soil down around it. Water the plant and keep it in medium to bright indirect sunlight. After 4-6 weeks, the roots should establish.