Indoors: Bright indirect light.

Keep your Heart fern consistently moist but not in soggy soil. Use filtered, bottled, or tap water that is sitting 24 hours to release the chemicals and water enough to discharge out of the drainage holes. Once the water is fully drained, replace them into the cache or decorative pot.

This heart fern enjoys and thrives in 70% humidity.

Warmer room temperatures and adding a humidifier to their surroundings will help them thrive.

This Heart Leaf fern thrives in bright indirect sunlight where temperatures are above 60°F and high humidity.

Apply a balanced, liquid fertilizer especially formulated for indoor plants every month. Apply during the spring, summer, and fall seasons. Let them rest during the winter.

When receiving the Heart Fern, do not repot immediately but wait at least 6-12 months or if the roots are beginning to get crowded and growing through the drainage holes.

Repot in the spring, using a 2 inches bigger pot to give the roots room to spread.

Place a piece of screening at the bottom of the container over the drainage hole to secure the soil and allow to drain. Use a rich, well-draining indoor potting mix amended with 25% compost and to help with fertility.

Water your plant in the old pot before transferring over and let sit an hour.

Add soil to the bottom to elevate the root ball. Lift the plant and release the roots against the existing planter. Use a clean knife or garden trowel to wedge between the pot and the soil to loosen.

Inspect the root ball. Notice if there are any dead or rotting roots and trim off with sterile pruners. If the plant is rootbound, cut through the roots to alleviate continued encircling.

Ensure the plant is sitting about 1 inch below the edge of the pot to avoid water spillage. Add more soil and backfill around the sides by tamping down. Fill up to the soil line but not over.

Water thoroughly, leaving the soil damp but not soggy. If settling occurs, add more soil.

Water well to dampen the soil and let them drain.

If the leaves on your fern dry out or become crispy, trim off the stems down to the base. Keep the base and roots moist and new fronds will form eventually. Place them on a pebble tray to keep the humidity high. Remove any debris on the soil and replenish if necessary.

Propagate and divide your Heart Fern in the spring.

Hydrate the plant the night before.

Pull from the container and brush or wash away the soil carefully around the roots. Carefully divide or cut through the clump with a sterilized knife. Repot the fern in rich, indoor peat-based potting soil Be aware that each new plant needs several leaves with sufficient roots attached.

Use a container 2 inches bigger than the root ball with drainage and deep enough for their roots to grow. Place the plant at the same level as the previous pot adding soil at the bottom.

Water the soil and add more soil if settling occurs.

Set them in medium to bright, indirect sunlight while they are rooting. Place a large, clear plastic bag, spritz with water on the interior and place over the new plant to create a humid environment.

Check the moisture and humidity each day and add misting to keep the soil moist while the roots establish.

After 6-8 weeks, roots will begin to establish. You can tug onto the stem to ensure the roots are anchoring well. Remove the plastic bag but keep the air humid around them with a pebble tray and misting.

Prefers medium levels of indirect light.

Water well and then allow the soil to dry out between each watering.

Enjoys humidity. Spritz occasionally.

Keep this plant in warmer temperatures and avoid drastic changes in temperature.

This plant likes warmer temperatures and can be acclimated to part shade to full sun over time. Bring in when temperatures dip below 35°F.

Add a time-release fertilizer to the top of the soil in the spring. This will be sufficient throughout the season. Do not fertilize in the fall and winter months.

When receiving the plant, do not repot immediately. Wait at least 6-12 months, or until the roots begin to crowd and grow through the drainage holes.

This plant likes to be a little snug in its pot so there is no reason to repot initially. If the soil is aged, repot in the spring, using a 2" bigger pot to keep the roots drier. Use a well-draining indoor potting mix with perlite to help with drainage or use a palm soil mix.

Place a piece of screening at the bottom of the container over the drainage hole to secure the soil and allow water to drain. Add soil to the bottom to elevate the root ball.

Be aware that the roots are brittle, so carefully remove as much soil around the roots as possible to replace the aged soil and fertilizer deposits.

Very carefully lift the plant and release the roots against the existing planter. Use a clean knife or garden trowel to wedge between the pot and the soil to loosen.

Inspect the root ball. Notice if there are any dead or rotting roots and trim off with sterile pruners.

Ensure the plant is sitting about 1" below the edge of the pot to avoid water spillage. Add more soil and backfill around the sides by tamping down. Fill up to the soil line but not over.

Water thoroughly, leaving the soil damp but not soggy. If settling occurs, add more soil.

Remove any dead fronds down to the base of the plant. Remove any debris on the soil and replenish soil when needed.

This plant is hard to propagate. We recommend getting a small plant to nurture!

Enjoys medium to bright indirect sunlight indoors or in full shade, frost-free outdoor areas.

Keep consistently moist but can be forgiving if neglected at times.

These plants enjoy high levels of humidity indoors and outside.

Keep this plant on the warmer side and avoid cold drafts.

Outside: Keep them in full shade on a patio out of direct sunlight to prevent leaf burn where nights are above 55°F

Apply at half-strength a balanced, liquid fertilizer especially formulated for indoor plants every month.

When receiving the Lemon Button Fern, do not repot immediately but wait at least 6-12 months or if the roots are beginning to get crowded and growing through the drainage holes. They prefer to be a little crowded in their pot.

Repot in the spring, using a 2 inches bigger pot to give the roots room to spread.

Place a piece of screening at the bottom of the container over the drainage hole to secure the soil and allow to drain. Use a rich, well-draining indoor potting mix amended with 25% compost and to help with fertility.

Water your plant in the old pot before transferring over and let sit an hour.

Add well-draining potting soil amended with peat moss and perlite to the bottom to elevate the root ball. Lift the plant and release the roots against the existing planter. Use a clean knife or garden trowel to wedge between the pot and the soil to loosen.

Inspect the root ball. Notice if there are any dead or rotting roots and trim off with sterile pruners. If the plant is rootbound, cut through the roots to alleviate continued encircling.

Ensure the plant is sitting about 1 inch below the edge of the pot to avoid water spillage. Add more soil and backfill around the sides by tamping down. Fill up to the soil line but not over.

Water thoroughly, and unlike their cousins, they like to have a bit drier soil conditions. If settling occurs, add more soil.

Water well to dampen the soil and let drain.

When watering your fern, it is an excellent time to trim off any browning, yellowing, or discolored leaves. Cut the stem all the way back to the base. To revitalize them, cut all the old foliage down to the crown and avoid cutting off any rolled fiddleheads that are popping up. This will eventually produce new foliage for the year and keep your plant healthy.

Propagate and divide your Lemon Button Fern in the spring.

Hydrate the plant the night before.

Pull from the container and carefully divide or cut through the clump with a sterilized knife. Repot the fern in rich, indoor peat-based potting soil mix amended with a rooting hormone. Be aware that each new plant needs several leaves with sufficient roots attached.

Use a container 2 inches bigger than the root ball with drainage and deep enough for their roots to grow. Place the plant at the same level as the previous pot adding soil at the bottom.

Water the soil and add more soil if settling occurs.

Set them in medium to bright, indirect sunlight while they are rooting. Place a large, clear plastic bag, spritz with water on the interior and place over the new plant to create a humid environment. This particular fern does better with dryer soil conditions. Water weekly and keep on a consistent schedule.

Check the moisture and humidity each day and add misting to keep the humidity high while the roots establish.

After 6-8 weeks, roots will begin to establish. You can tug onto the stem to ensure the roots are anchoring well. Remove the plastic bag but keep the air humid around them with a pebble tray and misting.

Medium to bright indirect light. Never direct sunlight.

Don't overwater. Too much water can cause root or crown rot.

Enjoys high humidity. Spritz occasionally.

Ideally, the Bromeliads grow best when temperatures are between 60°-80°F.

Outside: Grow in partial shade (4-6 hours) where nights are above 60°F.

Indoors: The Bromeliad prefers bright, indirect light for at least six hours in a southern, eastern and western windows.

Fertilize monthly during their growing period while the flower is in bloom with a balanced liquid fertilizer and a time release granular soil fertilizer. Reduce during the fall and winter months while the plant is in their dormant phase. When fertilizing, don't get the fertilizer in the urn or tank as this can burn the plant.

To repot a bromeliad grown out of their container, get a larger one that's 2 inches wider with drainage holes. Make sure the container is sturdy enough if the bromeliad is top-heavy.

Use a mixture of 1/2 well-draining potting mix, 1/4 perlite, and 1/4 orchid bark. Place a piece of screening at the bottom of the container over the drainage hole to secure the soil and allow to drain. Fill the container's bottom with the mix, then place the bromeliad in and fill around the edges. Leave at least an inch of room from the top of the container to avoid water spillage.

Water the plant well. Add them to an area with bright, indirect sunlight and humidity to let them settle into their new environment.

Remove the dead or dying part with some pruners back to the base. This simple pruning will give more light to the remaining pups with more room to stretch and make new baby bromeliads.

To propagate the bromeliad pups, let the pups grow on the mother plant until they reach at least 5 inches or a third of the original stalk's size. Take the mother plant out of the pot. Cut the mother plant top off to see the pup and remove all the dead leaves. Pull away the pup and the small root system with them. You may need to use pruners to help remove the roots and pup. Some arm strength may be required to wedge them away from the parent plant. Once you have them separated, you can use a bromeliad medium (1/2 well-draining potting mix, 1/4 perlite, and 1/4 orchid bark) to repot them in. Use a container with drainage holes and nothing too big for the pup. Allow at least 2 inches of soil to surround the pup. You will bury the roots very shallow in the soil so as not to cause rotting on the leaves. Tamp the mix down to secure the plant. Water from overhead to give them a drink and water well so it drains through the hole. Set in a bright, indirect sunny area.